Browse Categories
Search
What are you looking for?
Products

ANNIN Patriot Aluminum Flag Pole Kit w/ Flag

MSRP: $193.00
Price: $154.40
You Save: $38.60 (20 %)
Item Number: P20F

ANNIN Patriot Aluminum Flag Pole Kit w/ Flag (P20F):

  • Aluminum 20' Height Outdoor Flagpole
  • 2" Diameter
  • 5 sections for quick and easy assembly
  • Comes with:
    -One 3' x 5' flag
    -G
    round sleeve
    -Gold anodized ball
    -Aluminum truck with nylon sheave
    -Poly halyard
    -Nylon snaps
    -Cleat

     Instructions for Patriot Flagpole
     
    1. Dig a hole 2 inches deeper than length of ground sleeve and approximately twice its diameter. Line bottom of hole with 3 inches of tamped stone for drainage.
    2. Prepare a concrete reinforcing mixture- 1 part cement, 2 ½ parts sand & 5 parts stone.
    3. Wet down hole with water so that earth doesn't take water away from the concrete.
    4. Set sleeve upright in center of hole and fill in around it with concrete mixture. Be sure sleeve extends ½" to 1" above ground after final grading. Use a level at two points on the sleeve 90 degrees apart to make sure its plumb. Check plumb several times while filling hole. Level off smoothly at top. Do not allow concrete to get into or under sleeve.
    5. Assemble pole sections by sliding together, with swaged ends extending upwards into next section. The top section is un-swaged. The second section from the bottom is drilled for the cleat. The three remaining sections make up the rest of the pole and are interchangeable. Attach cleat, using the self-tapped screws supplied.
    6. Screw ball ornament into top of truck. Thread halyard through pulley and tie ends together. Secure truck to top of pole, using a screwdriver to tighten set screws. Make sure pulley is aligned with cleat.
    7. To affix snap hooks:
      a) Pinch halyard between thumb and forefinger, forming loop.
      b) Push loop through eye in snap hook-continue pushing until loop reaches end of snap hook.
      c) Bring loop over end of snap-fold back towards halyard.
      d) Pull snap hook in opposite direction, thus tightening it into position.
      e) Affix second snap hook the appropriate distance above the first, according to the size of the flag
      being flown (example- approx. 3' for a 3x5' foot flag.
    8. When concrete has set, insert butt end of pole until fully seated in sleeve. Rotate pole until pulley faces in opposite direction from prevailing wind. Use strip of caulking (Mortite, for example) to seal space between sleeve and pole.

Product Reviews

(0 Ratings, 0 Reviews)
Shopping Cart
Your cart is empty.

 

Mailing Lists
Join our Mailing List!Receive periodic Product Updates and Sale Notifications!